€ 9,45
It is a multifunctional HUB with PDB, new STOSD8-SE, BEC 5V/1.5A(2A Max.) &10V/1.5A(2A Max.), Current sensor 184A, 3~6S LiPo supports. It is specially made for the mini FPV Quad. Built-in STOSD8-SE can support Plug & Play, no complicated settings needed.
Matek HUBOSD8 SE
Specs:
Input voltage range: 9 - 27VDC(3~6s LiPo) w/ TVS protection PDB: 4x30A (Max.4x46A) Regulated 5V(POSCAP filtered) and 10V(MLCC filtered) outputs Current Sensor 184A Built-in STOSD8-SE Physical: - 2oz copper, 4-layers & 2mm PCB. - 1x Battery input, 4x ESC outputs. 2x BEC 5V outputs, 2x BEC 10V outputs. - Camera signal & Gnd pads, Video Transmitter Signal & Gnd pads - 1x Serial port (RX, TX, G) - RSSI input pad & Current sensor output pad - Dimensions: 46x36x4mm, Weight: 9g - Mounting holes 30.5mm square spacing，Φ3mm Continuous current: 30A per output Peak current (5 seconds/minute): 46A per output Designed for RC Receivers, Flight controllers, OSD, and Servos. Voltage: 5.0 +/- 0.1VDC Continuous current: 1.5 Amps (Max.2A 10s/minute) Output Ripple: 23mV (VIn=24V, VOut=5V@1.5A load) Short-circuit tolerant (2 seconds/minute) Designed for Video TX or FPV camera. Voltage: 10.0 +/- 0.2VDC Continuous current: 1.5 Amps (Max.2A 10s/minute) Output Ripple: 15mV (VIn=24V, VOut=10V@1.5A load) Short-circuit tolerant (2 seconds/minute) 10V can be used to power cameras labeled as 12V The 3S LiPo input voltage should be 10.8V plus 184A Max. Current signal output: 3.3V ADC for Flight controler Tips: If current signal pad is connected to FC, The CURRENT METER must be ON in FC GUI. Scale the output voltage to milliamps(1/10th mV/A): 179